RAD-Galaxy

• Fourth-generation neoVI architecture: over 10x the performance of earlier devices
• Low power consumption
• Power Supply: 4.5-40V operation
• 20 LEDs indicate link status and logger status
• Temperature Range: -40°C to +85°C
• One-year limited warranty
• Field-upgradeable flash firmware
• Four MISC I/O channels configurable as 0-40V analog input or PWM input or output
• Three 0-5V analog outputs
• Standalone mode including scripting, receive messages, transmit messages, expressions, I/O, and transport layers
• J2534 and RP1210 A/B compatible for CAN/ISO15765
• Full-size SD card slot with support for cards with capacities up to 128 GB (or the limit of newer SDHC cards); card is formatted using FAT32 for PC compatibility.
• Battery-backed real time clock (RTC).
• Dimensions: 10.63” x 4.53” x 1.57” (27cm x 11.5cm x 4cm)
• Weight: 1.42 lbs (645g)

Timing Specifications

• FPGA-measured 64-bit timestamping with 10 ns accuracy on all CAN/LIN/Ethernet networks
• Simultaneous operation on all CAN/LIN/Ethernet networks
• Transmit message double-buffering on all networks, allowing back-to-back message transmission

Network Specifications – Automotive Ethernet

• 12 Broadcom BroadR-Reach® (100BASE-T1) Automotive Ethernet physical layer transceivers
• PHYs can be configured to operate as active taps for up to 6 node pairs, media converters for up to 12 nodes, or a combination of up to 6
• Full-duplex operation on all links
• Automatic master/slave configuration

Network Specifications – CAN

• 6 Dedicated ISO11898 Dual Wire CAN channels with ISO CAN FD support
• 2 additional CAN channels switchable between ISO CAN FD or SW CAN (GMW3089 / SAE J2411)
• Up to 1 Mb/s software-selectable arbitration phase baud rate
• Up to 8 Mb/s software-selectable data phase baud rate for CAN FD
• Listen-only mode support
• Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support
• CAN FD implemented using the Bosch MCAN CAN Controller IP

Network Specifications – LIN

• 1x LIN (Local Interconnect Network)
• Full support for LIN 1.X, 2.X and J2602
• LIN J2602 / 2.X compatible physical layer
• Software-enabled 1K LIN Master Resistor per channel
• LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
• LIN Bus Master Mode operates at same time as LIN Bus Monitor
• LIN Bus Slave simulation, with or without an LDF file
• LIN Bus hardware schedule table with support for LIN diagnostics

• Software-selectable baud rate

Network Specifications – DoIP/XCP/Automotive Ethernet

• 10/100/1000 Ethernet PHY with low-power mode
• DoIP activation line implemented with LIN channel

* Specifications subject to change. Please contact Intrepid for the latest information.