neoOBD 2 PRO
Open Platform OBD Interface for Automotive Enterprise IoTDevice Specifications
- Low power consumption
- Power supply: 4.5-40V operation
- Four full-color status LEDs
- Temperature range: -40°C to +85°C
- Vehicle connectors: 16-pin OBD 2 male and 16-pin OBD 2 female
- One-year limited warranty
- Field-upgradeable flash firmware
- Microsoft-certified USB drivers
- USB Type-C Host for neoVI MIC GPS or powering accessories like a Raspberry PI drawing up to 3A at 5V
- High speed (480 Mbits/sec) USB interface
- Standalone mode support, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
- J2534 and RP1210 A/B compatible for CAN/ISO15765-2:2016 (CAN FD)
- On-board 64 MB flash storage
- Battery-backed real time clock (RTC)
Timing Specifications
- 64-bit timestamping to an accuracy of 25 nanoseconds on CAN FD networks and 10 microseconds on LIN networks with no overflow
- Accuracy of 0.5 microseconds possible if using only one network
- Simultaneous operation on all CAN/LIN networks
- Transmit message double-buffering on all networks, allowing back-to-back message transmission
Network Specifications – CAN
- 4x ISO CAN FD channels implemented using the industry standard Bosch MCAN CAN FD core
- CAN 2.0B compatible for all CAN networks
- 4 dedicated ISO11898 Dual Wire CAN FD physical layers (MCP2562FD)
- 1 dedicated Single Wire CAN physical layer GMW3089 / SAEJ2411 (MC33897)
- Up to 1 Mb/s software-selectable baud rate for arbitration phase (auto baud capable)
- Up to 8 Mb/s software-selectable baud rate for data phase (auto baud capable)
- Listen-only mode support
- Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support
Network Specifications – LIN, ISO9141, Keyword 2000 or K and L Line
- 2x LIN (Local Interconnect Network)
- Full support for LIN 1.X, 2.X and J2602
- LIN J2602 / 2.X compatible physical layer
- Software-enabled 1K LIN Master Resistor per channel
- LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
- LIN Bus Master Mode operates at same time as LIN Bus Monitor
- LIN Bus Slave simulation, with or without an LDF file
- LIN Bus hardware schedule table with support for LIN diagnostics
- Initialization Waveforms, including Fast Init, Five Baud, and Custom
- Software-selectable baud rate
Network Specifications – DoIP / XCP / Automotive Ethernet
- 10/100 Ethernet PHY with low-power mode
- Compatible with 100BASE-T1 / BroadR-Reach® using Intrepid RAD-Moon media converter accessory
- Software-controlled DoIP activation line
* Specifications subject to change. Please contact Intrepid for the latest information.