1-800-859-6265   FAX: +1 (586) 731-2274
Select Page

RAD-A2B Specifications

General Specifications

  • Interface to PC via 1G Ethernet or Isolated USB 2.0 (240 Mb/s)
  • Low power consumption
  • Power supply: 6-40V operation via barrel jack; use included power supply or vehicle power
  • Ten scriptable, multi-color LEDs indicate link status and modes of operation
  • Temperature range: -40°C to +85°C
  • One-year limited warranty
  • Field-upgradeable flash firmware
  • Standalone mode, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
  • Dimensions: 5.41” × 3.43” × 1.43” (13.7 × 8.72 × 3.62 cm)
  • Weight: 0.65 lb (295 g)

Timing Specifications

  • FPGA-measured 64-bit timestamping with 10 ns accuracy on all CAN FD networks
  • Simultaneous operation on all CAN FD networks

Network Specifications

  • AD2433 for the A2B transceiver
  • 1x A2B Monitor
  • 1x A2B Emulator (transmit and receive) Node
  • 2x CAN / CAN FD channels: two dedicated ISO11898 Dual Wire CAN physical layers (TJA1043T)
  • Software-switchable between ISO CAN FD and non-ISO (Bosch) CAN FD versions
  • Up to 1 Mb/s software-selectable baud rate for arbitration phase
  • Up to 8 Mb/s software-selectable baud rate for data phase
  • Listen-only mode support
  • CAN FD implemented using the Bosch MCAN CAN controller IP
  • Software-selectable termination resistors for CAN channels
  • 1x LIN (Local Interconnect)
  • Full support for LIN 1.X, 2.X and J2602
  • LIN J2602 / 2.X compatible physical layer
  • Software enabled 1K LIN Master Resistor per channel
  • LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/ Slave Not Responding, Checksum Error and Transmit Bit Errors
  • LIN Bus Master Mode operates at same time as LIN Bus Monitor
  • LIN Bus Slave simulation – with or without an LDF file
  • LIN Bus hardware schedule table with support for LIN diagnostics
  • Software-selectable baud rate

Ordering Information

Part Number Description
RAD-A2B Automotive Audio Bus and Network Monitoring Solution

Specifications subject to change; please contact Intrepid for the latest information. All trademarks are the property of their respective owners.

 

JapanKoreaChinaUSA