1-800-859-6265

neoOBD 2 LC

Low-Cost Open Platform OBD Interface for Automotive IoT

Device Specifications

  • Low power consumption
  • Power supply: 4.5-40V operation
  • Four full-color status LEDs
  • Temperature range: -40°C to +85°C
  • Vehicle connectors: 16-pin OBD 2 male One-year limited warranty
  • One-year limited warranty
  • Field-upgradeable flash firmware
  • Microsoft-certified USB drivers
  • USB Type-C Host for neoVI MIC GPS or powering accessories like a Raspberry P drawing up to 3A at 5V
  • High speed (480 Mbits/sec) USB interface
  • Standalone mode support, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
  • J2534 and RP1210 A/B compatible for CAN/ISO15765-2:2016 (CAN FD)
  • On-board 64 MB flash storage
  • Battery-backed real time clock (RTC)

Timing Specifications

  • 64-bit timestamping to an accuracy of 25 nanoseconds on CAN FD networks and 10 microseconds on LIN networks with no overflow
  • Accuracy of 0.5 microseconds possible if using only one network
  • Simultaneous operation on all CAN/LIN networks
  • Transmit message double-buffering on all networks, allowing back-to-back message transmission

Network Specifications – CAN

  • 4x ISO CAN FD channels implemented using the industry standard Bosch MCAN CAN FD core
  • CAN 2.0B compatible for all CAN networks
  • 4 dedicated ISO11898 Dual Wire CAN FD physical layers (MCP2562FD)
  • 1 dedicated Single Wire CAN physical layer GMW3089 / SAEJ2411 (MC33897)
  • Up to 1 Mb/s software-selectable baud rate for arbitration phase (auto baud capable)
  • Up to 8 Mb/s software-selectable baud rate for data phase (auto baud capable)
  • Listen-only mode support
  • Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support

Network Specifications – LIN, ISO9141, Keyword 2000 or K and L Line

  • Up to 1x LIN (Local Interconnect Network)
  • Full support for LIN 1.X, 2.X and J2602
  • LIN J2602 / 2.X compatible physical layer
  • Software-enabled 1K LIN Master Resistor per channel
  • LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
  • LIN Bus Master Mode operates at same time as LIN Bus Monitor
  • LIN Bus Slave simulation, with or without an LDF file
  • LIN Bus hardware schedule table with support for LIN diagnostics
  • Initialization Waveforms, including Fast Init, Five Baud, and Custom
  • Software-selectable baud rate
  • DoIP / XCP / Automotive Ethernet 10/100 Ethernet PHY with low-power mode Compatible with 100BASE-T1 / BroadR-Reach® using Intrepid RAD-Moon media converter accessory Software-controlled DoIP activation line

* Specifications subject to change. Please contact Intrepid for the latest information.

JapanKoreaChinaUSA