IVNT-03 Network Specification
8 x CAN / CAN FD Channels
- 8 x ISO CAN FD Channels implemented using the industry standard Bosch MCAN CAN FD Core
- CAN 2.0B compatible for all Classical CAN Networks
- Software selectable between ISO CAN FD and NON ISO CAN FD (BOSCH CAN FD)
- 6 Dedicated ISO11898 Dual Wire CAN FD Physical Layer (MCP2561FD)
- 2 Selectable CAN Channels with CAN mode and 3 software-selectable PHY options
- DW CAN mode: 2 dedicated ISO 11898 Dual Wire CAN FD physical layers (MCP2561FD)
- LSFT CAN mode: 2 Low Speed Fault Tolerant CAN physical layers (TJA1055)
- SW CAN mode: 2 Single Wire CAN physical layers GMW3089 / SAE J2411(MC33897)
- Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support
- Up to 1 Mb/s software-selectable baud rate for arbitration phase (auto baud capable)
- Up to 8 Mb/s software-selectable baud rate for data phase (auto baud capable)
- Listen-only mode support
- Four software programmable DW CAN termination circuits
4 x LIN (Local Interconnect Network)
- 4 x LIN (Local Interconnect)
- Full support for LIN 1.X, 2.X and J2602
- LIN J2602 / 2.X compatible physical layer
- Software enabled 1K LIN Master Resistor per channel
- LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
- LIN Bus Master Mode operates at same time as LIN Bus Monitor
- LIN Bus Slave simulation – with or without an LDF file
- LIN Bus hardware schedule table with support for LIN diagnostics
- Software-selectable baud rate
