RAD-Gigastar

Device Specifications

• neoVI 5G Architecture over 10x performance over previous devices
• Power Consumption (typical): 0.5A @ 12.0 VDC
• Power Supply: 4.5-36 Volt Power Operation
• Multi colored LEDs to indicate status/activity on all the networks
• Temperature Range: -40C to +85C
• Warranty: One Year Limited Warranty
• Firmware: Field upgradeable design (flash firmware)
• RP1210 A/B compatible for CAN/ISO15765, Keyword, and ISO 9141
• Isolated USB 2.0. Operates up to 240 Mbps throughput
• Time synchronization – can sync its local 10ns resolution RTC with other Intrepid devices through CAN/ BroadR networks
• Power management – supports sleep and wake up on CAN networks
• Dimensions: 7.30” x 4.4” x 1.6”.
• Light weight: less than 1 lb. (.45 kg).

Networks – General

• FPGA measured 64 bit timestamping with 10ns accuracy on all CAN/Ethernet networks.
• Simultaneous operations on all CAN/Ethernet networks.
• Transmit message double-buffering on all networks allows back to back message transmission.

2x 1000BASE-T1(BroadR-Reach®) Channels

• 2x 100/1000BASE-T1 using the Marvell 88Q2112 PHY
• Automatic Master / Slave Configuration
• Link Up / Down Status monitoring
• Signal integrity monitoring
• Ethernet error reporting through specially designed MAC.
• 780ns Rx, 240ns Tx and 300ns internal latency (Total: 1,320ns)
• PTP – Precision Time Protocol support
• 100/1000BASE-T1 ports can be configured to be in Media converter/ Tap modes
• LEDs in the membrane to display the link, activity, mode and signal strength for the BroadR networks
• Implements Intrepid’s specially designed MAC layer. This allows future layer 2 changes as a firmware update to the device allowing same hardware to support growing industry changes.

Network Specifications

6x CAN FD Channels

• 2 Dedicated ISO11898 Dual Wire CAN Physical Layer
• Software switchable between ISO CAN FD and Non ISO CAN FD versions
• Up to 1 M-Bit Software Selectable Baud Rate for arbitration phase
• Up to 8 M-Bit Software Selectable Baud Rate for data phase
• Listen only mode support
• CAN FD implemented using the Bosch MCAN CAN Controller IP

2x FlexRay receive channels with selectable on-board termination

1x LIN / K Line / KW2K / ISO 9141

• Up to 1x LIN (Local Interconnect Network)
• Full support for LIN X, 2.X and J2602
• LIN J2602 / X compatible physical layer
• Software-enabled 1K LIN Master Resistor per channel
• LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/ Slave Not Responding, Checksum Error and Transmit Bit Errors
• LIN Bus Master Mode operates at same time as LIN Bus Monitor
• LIN Bus Slave simulation, with or without an LDF file
• LIN Bus hardware schedule table with support for LIN diagnostics
• Initialization Waveforms, including Fast Init, Five Baud, and Custom Software-selectable baud rate