Automotive Ethernet Media Converters
Bridge the Gap Between Conventional and Automotive Ethernet자동차 이더넷용 미디어 컨버터
미디어 컨버터는 자동차용 이더넷 네트워크 테스트 및 검증의 첫 단계 중 하나입니다. 자동차용 이더넷 트래픽은 버스와 같은 버스에 사용되는 동일한 기술을 사용하여 모니터링할 수 없습니다. CAN. 이더넷 네트워크는 스타 토폴로지를 사용하므로 전체 네트워크를 모니터링할 단일 지점이 없습니다. 또한, 사용되는 정교한 기술로 인해 전압 레벨에서 비트 값을 직접 해석할 수 없습니다.
간단히 말해서 자동차 이더넷 연결을 표준 4/8 와이어 연결에 연결해야 하는 경우 PC/장치로 트래픽을 전송하기 위해 미디어 컨버터가 필요합니다.
선도적인 미디어 변환 기술 공급업체로서, 저희는 안정적이고 효율적인 자동차용 이더넷 미디어 컨버터의 중요성을 잘 알고 있습니다. 저희 RAD-Moon 및 RAD-Comet 시리즈를 사용하면 호환성 문제 걱정 없이 차량의 개별 시스템에 쉽게 접근하고, 도구를 테스트하고 사용할 수 있습니다.100BASE-T1, 1000BASE-T1, 2.5GBASE-T1, 5GBASE-T1, 10GBASE-T1 “Multi-Gig” 그리고 10BASE-T1S 자동차 이더넷 및 1000BASE-TX 이더넷 커넥터용 미디어 컨버터를 사용하면 다양한 유형의 미디어에 연결하고 신호를 손쉽게 변환할 수 있습니다. 또한, 컴팩트한 디자인과 간편한 설치로 자동차 업계 종사자라면 누구에게나 필수적인 도구입니다..
Products – Simple, Inexpensive, Yet Powerful
자동차 이더넷 미디어 컨버터 제품
RAD-Moon - 100BASE-T1 Converter
The inexpensive, pocket-sized RAD-Moon easily interfaces conventional Ethernet with BroadR-Reach® (100BASE-T1 compatible). Powered by USB, the RAD-Moon allows you to communicate directly between a PC and an Automotive Ethernet ECU.
RAD-Moon 2 - 1000BASE-T1 Converter
RAD-Moon 2 allows you to convert from 100/1000BASE-T1 Automotive Ethernet to standard 10/100/1000 Ethernet, useful for connecting a PC to a 100/1000BASE-T1 host or switch.
RAD-Moon 3 - 2.5/5/10GBASE-T1 Converter
RAD-Moon 3 converts the Ethernet physical layer from 2.5GBASE-T1, 5GBASE-T1, 10GBASE-T1 “MultiGig” to MultiGBASE-T. This is needed to directly connect a PC equipped with the standard 8-wire Ethernet to an automotive ECU or Switch which use the 2-wire version of Ethernet specific to In-Vehicle Networks. (IVNs)
RAD-Moon-T1S - 10BASE-T1S Media Converter
The Intrepid RAD-Moon family of Media Converters has a new member supporting the latest Automotive Ethernet technology. 10BASE-T1S is a low-cost, low-speed, multidrop version of Automotive Ethernet widely considered for the replacement of CAN and CAN FD.
RAD-Comet 3 - 10BASE-T1S Converter
The RAD-Comet 3 is a versatile device for developing and testing 10BASE-T1S communication in automotive systems. It can be programmed to simulate a node on a 10BASE-T1S network as well as capture and analyze 10BASE-T1S traffic simultaneously with other vehicle networks.
RAD-Comet 2 - 10BASE-T1S Converter
The RAD-Comet 2 is a versatile device for developing and testing 10BASE-T1S communication in automotive systems. It can be configured and used to simulate a node on a 10BASE-T1S network as well as capture and analyze 10BASE-T1S traffic simultaneously with other vehicle networks.
RAD-Meteor - 10BASE-T1S Converter
Intrepid’s RAD-Meteor is a cost effective means to add a 10BASE-T1S (IEEE Std 802.3cg) port to your computer using USB. In addition to monitoring 10BASE-T1S traffic as if it were a standard Ethernet port, the RAD-Meteor network adapter supports the test modes and wave forms required to test the 10BASE-T1S network.
미디어 컨버터 비교 차트
| Products | RAD-Moon 3 | RAD-Moon 2 | RAD-Moon-T1S | RAD-Comet 3 | RAD-Meteor | RAD-Moon |
| Automotive Ethernet Network | 2.5/5/10GBASE-T1 "Multi-Gig" | 100/1000BASE-T1 | 10BASE-T1S, 10/100/1000BASE-T | 6x 10BASE-T1S | 10BASE-T1S | 100BASE-T1 |
| PHY | Marvell (88Q4364) or MV-Q3244 | Marvell (88Q2220M) | ADI AD330x | ADI AD330x | Microchip LAN867X | NXP (TJA1100) |
| Connector | H-MTD (Optional MATEnet Adapter Cable) | H-MTD (Optional MATEnet Adapter Cable) | iX Industrial | H-MTD, iX Industrial | Terminal Block | Molex Mini50 |
| Voltage Input | 6-40V | 4.5-40V | 5.5V-40V | 5.5V-40V | 125mA at 5 V (bus load 1%), 140 mA at 5V (Test Mode 1) | 250 mA @ 5V or about 1.25W |
| Power | Barrel Jack | Ruggedized USB Type-C or Barrel Jack | Barrel Jack | Barrel Jack | USB Type-C | Mini-USB |
| Configure | Ruggedized USB Type-C connector for device configuration and firmware updates | Ruggedized USB Type-C for configuration and PHY register monitoring | Ruggedized USB Type-C connector for device configuration and firmware updates | Ruggedized USB Type-C connector for device configuration and firmware updates | USB Type-C | Mini-USB |
| TC10 | Yes | Yes | Yes | Yes | No | No |
| MACsec | Yes (MV-Q3244) | Yes | No | Yes | No | Yes |
| Barrel Jack | Yes | Yes | Yes | Yes | No | No |
| Programmable membrane label with LEDs | Yes | Yes | Yes | Yes | No - Display | No |
| Vehicle Spy 3 Support | Yes | Yes | Yes | Yes | No | No |
| Learn More | RAD-Moon 3 >> | RAD-Moon 2 >> | RAD-Moon-T1S >> | RAD-Comet 3 >> | RAD-Meteor >> | RAD-Moon >> |
Related Products:
RAD-Gigastar
The RAD-Gigastar can monitor one pair of 100/1000BASE-T1* connections with an additional pair of SFP cages to support optical/ copper SFP transceivers. In addition, the RAD-Gigastar can also operate as a programmable gateway to create an Ethernet-to-Ethernet or a CAN-Ethernet gateway.
RAD-Jupiter
Intrepid’s RAD-Jupiter is a rugged 7-port managed switch designed specifically for bench and vehicle network development. In addition to its Ethernet functionality, it integrates many of the key CAN, LIN, and scripting features found in our ValueCAN 4 family of tools.
RAD-Galaxy
The RAD-Galaxy is a BroadR-Reach® (100BASE-T1) multi active-tap / media converter with 12 Automotive Ethernet and 8 CAN FD channels.
